[ Main ] | [ Setup ] | [ Status ] | [ Utilities ] | [ Help ]

  Non-Windows Setup


Actiontec DSL Gateway Setup Page
The following will setup the router to work with your DSL provider.

The Actiontec DSL Gateway setup page can be used to setup your Gateway for the following configurations.
1) RFC1483 Bridged with DHCP. Bridging session terminated in the GT701-WG; via a DHCP address from the ISP. DHCP/NAT is used on the LAN side to run multiple LAN devices. (Same for RFC1483 Routed)
2) RFC1483 Bridged with Static IP. Bridging session terminated in the GT701-WG; via a single Static IP address from the ISP. DHCP/NAT is used on the LAN side to run multiple LAN devices. (Same for RFC1483 Routed)
3) PPPoA with dynamic IP Addressing. (Same for PPPoE)
4) PPPoA with a Single Static IP Address. (Same for PPPoE)

The advanced configuration session must be used to set the Gateway for transparent bridging and PPPoA with a block of static IP addresses.

Please locate your Internet Service Provider(ISP) worksheet. The ISP worksheet is required to complete the following. The ISP worksheet is sent separately from your DSL fulfillment package directly from your ISP of choice. If you do not have an ISP worksheet, please contact your ISP directly.

ISP Protocol
Please select the protocol below listed on your ISP worksheet.

RFC1483 Bridged
RFC1483 Routed
PPPoA
ISP Username
ISP Password
PPPoE
ISP Username
ISP Password

IP Configuration
Please select your ISP addressing scheme listed on your ISP worksheet.

Dynamic
Static
IP
Subnet
Gateway

DNS Configuration

Dynamic
Static
Primary DNS
Secondary DNS

NOTE: This page will setup the router for use with your DSL provider. In addition to setting up the router you may be required to perform additional configuration changes on your computer.

Thank you for choosing DSL as your high-speed access of choice.

Please click the Save and Restart button below to save your settings and restart your Gateway.



Copyright 2001, 2002, 2003 Actiontec Electronics Inc.